Thursday, January 24, 2019

Woodlawn Projects

After my "retirement", we're beginning a few projects around the house.

First on the list is repairing our fifth-wheel RV. We found *lots* of rot on the back wall and the sides adjacent to the corners. Sigh.

Second, our house (bought September 2016) came with a falling-down garage. You could see through the walls and roof. Our original intent was to tear down and replace with a hobby room for Jennifer, and we had begun this process before I went on strike. One wall and the roof removed. A real eyesore for our neighbors. So the current idea is to just create a sealed structure that we can decide about later.

Third, we want to renovate and remodel our sunporch. Not such a big job, and actually the one I would like to tackle first.

Details and photos later.

Tuesday, November 20, 2018

Friday, August 19, 2016

sofa table

this is a sofa table made of zebra wood and wenge

Monday, June 16, 2014

A little project

I built a yarn winder from plans by Clayton Boyer. Gears and bearings and stuff moving! The bits were cut on both of my CNC machines. It took longer to build the first time than I anticipated, but the second one should be easier. 



Friday, April 4, 2014

Roxie

A cnc cut bit of art-- the mascot fot the Rock City Dance folks


CNC made iris

I made this on the cnc machine from plans on the internet. Gcode provided by request. 

Ted's Table

A Sketchup rendering of a table for Ted. This is a countertop table, 36 inches tall and 54 inches on a side. The sides are flat, but could have a curve if desired. The aprons are 4 inches tall. The legs are 3 inches square at the top, tapering on the inside to a 2x2 square at the foot.